Sika Aquaseal Waterproof Tanking Membrane, Blue, 5 Litre

Product Information

Then we applied the Aquaseal primer with a 3 inch brush to the floor and the walls. This could be done with a bigger brush or even a fleece roller.

A ready to use primer, applied by brush to all porous and semi porous surfaces in the areas that are to Pay careful attention to edges and corners to ensure that the coverage in these areas is always consistent as these are the potential weak spots where leakage could occur.Aquaseal Waterproof Tanking Membrane 5LTR Forms a permanently flexible watertight membrane, applied by brush, two coats. Also, at this point it is worth noting that Everbuild’s Aquaseal Tanking Systems, both standard (4.5 square metres) and large (7.5 square metres) come with a paint brush and a roller. Our only criticism of the entire kit is that 2 brushes may well have been better.

Everbuild Aqualseal Wet Room Tanking System Kit for 4.5sq Metres What is in the Standard Size Aquaseal Wet Room and Tanking Kit From Everbuild? Aquaseal Waterproof Tanking Tape 10MTR Self adhesive joint corner sealing tape. Easy to apply with pre-cut release liner.Our tile adhesives collection will also assist in wet room construction. There’s ready-mixed tile adhesive as well as a practical adhesive and grout mixture. The membrane itself, despite being very thin (which allows it to flow onto the wall easily) is incredibly flexible as you would expect from any tanking system put into a high humidity area. Use in showers, wet rooms, wet zones in bathrooms and other tiled areas subject to water exposure such as balconies and partially covered external areas.

Aquaseal Tanking Tape provides cross directional movement at corners and on board joints and is available in 10 Metre rolls. Apply by brush in two coats which should be applied in different directions at right angles to each other to ensure full surface coverage is achieved with no weak spots. Aquaseal Waterproof Tanking Tape (10MTR) - Self adhesive joint and corner sealing tape. Easy to apply with pre-cut release liner.litre of liquid tanking primer (Styrene Acrylic based polymer) with a drying time of 1 – 2 hours depending on temperature of bathroom or wet room. For very porous surfaces, such as plasterboard, two coats will be required Then the vertical joints in the wall were sealed and all tape was pressed down thoroughly with the roller that is supplied with the wet room kit. The Aquaseal Wet Room System is designed to provide a permanently flexible watertight membrane prior to tiling.